kenwood ps400m amplifier

Home / the12volt's Install Bay / Car Audio / kenwood ps400m amplifier (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

shaneo

Member - Posts: 2

Joined: April 18, 2003

Posted: April 18, 2003 at 3:04 PM / IP Logged

I have a kenwood ps400m amplifier and when everything is hooked up the amp turns on and the light is green but after it clicks it goes red and into a safe mode all of the fuses are fine and im running out of patience please help with any info, links or anything that might help

thanks a lot

shaneo

Cletis

Copper - Posts: 59

Joined: March 26, 2003

Location: United States

Posted: April 18, 2003 at 3:52 PM / IP Logged

how do you have the amp wired up, and what do you have it hooked up to.

shaneo

Member - Posts: 2

Joined: April 18, 2003

Posted: April 18, 2003 at 4:14 PM / IP Logged

The amp is wired to the batterie with 4 ga. wire the amp is mono so it is only hooked to one sub i think the power and ground connections are good.

hope this helps a little

shane

Cletis

Copper - Posts: 59

Joined: March 26, 2003

Location: United States

Posted: April 18, 2003 at 4:16 PM / IP Logged

what kind of sub (single or dual voice coil), how many ohms are each coil, and if a dvc, how is it wired (series or parallel)

Cletis

Copper - Posts: 59

Joined: March 26, 2003

Location: United States

Posted: April 18, 2003 at 4:32 PM / IP Logged

I'm not too familiar with kenwood amps, but i just downloaded the manual and it says that red indicates normal operation. If the light is green it means you have a problem. It is supposed to start green and then turn red after a few seconds. Is the amp working correctly.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

kenwood ps400m amplifier

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.