the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

rattler 300


Post ReplyPost New Topic
< Prev Topic Next Topic >
screen_abq 
Member - Posts: 1
Member spacespace
Joined: October 21, 2010
Location: New Mexico, United States
Posted: October 21, 2010 at 9:28 PM / IP Logged  
I have a rattler 300 installed on 1998 toyota tacoma. I want to deinstall it. what are the correct steps to deinstall it with out frying the ecu. I thought I could just take out all the wiriring?????
brhaugen 
Copper - Posts: 275
Copper spacespace
Joined: September 30, 2005
Location: North Dakota, United States
Posted: October 22, 2010 at 7:45 AM / IP Logged  
In general you need to trace all wires back to their source and cut and tape. Don't leave "dead" wires laying around.
If any wires were cut during the installation - restore them by soldering.
If you are worried about the ECU - disconnect the battery first.
Brent Haugen
Fargo, ND

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, June 28, 2022 • Copyright © 1999-2022 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer