door lock 5902 in '02 ram

I know this is a basic question, but I can't get the door locks figured out. Everything else is done. Are the door locks single or double pulse? I have actually tried both, but just can't get it to work. I removed a Command Start CS-310i, so I tried just wiring the 5902 into the relays already installed but it won't work. They were running two relays running into the one WHITE/ green wire as mentioned in all the wiring diagrams. I have not checked what if any resistors are installed yet. Thanks much in advance!

If the door locks were working with the other alarm, the resistors must be there.

	Power Unlock		WHITE/ GREEN		(-)		DR. KICK PANEL USE 320 OHM RESISTOR
	PowerLock		WHITE/ GREEN		(-)		DR. KICK USE 680 OR 815 OHM RESISTOR

That's what I was thinking, but it won't work, even with swapping wires. Guess I'll try checking the resistance or the relay wiring. Is there any point to the relays or can I just diode isolate? Cheers in advance.

You definitely need relays with the 59XX series. I've done an 04 Ram, (probably about 10 in the UK) and I had to use double pulse lock and unlock. Just ground each lead first to see if the locks work.

On those relays, signal from alarm to 85, 12Volt+ constant, fused 1amp to 86, ground to 87 and output via the resistor from 30. What would diode isolation achieve, the end result is a ONE wire multiplex.

Works great, thanks! Single pulse works perfect on my '02.