clutch bypass

Anyone know how to bypass the clutch for a 2008 ford fusion?? i read 5v on the switch.

  im installing  a prostart CT-3271.

thanks in advance

Eri

There are two switches for the clutch. Did you grab the right one to meter ?Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

yes i did,  push switch engine start ,

 i read + 5 v on meter, clutch not pressed, clutch pressed reads 0 V, main switch on (engine off).

 the other is cruise control switch.

hi, blue/orange (neg) ...receives ground when pedal is depressed fully. configure the jumper at back of module to starter 2 to allow green wire (on main power connector) to be a second starter wire. have that trigger a relay to supply a ground to blue orange. relay connections... term 86 (green, 2nd start), term 85 & term 30 (ground), term 87 (blue/orange, clutch position switch)

thanks!!!

 ill try it tomorrow

  regards

 E

HI everyone, i got everything almost done just having a doorpin problem on the ready mode.

i found the solution but how do i wire the relay? any input will be appreciated, thanks!

R.A.P. SHUT DOWN	GREEN/ violet	In Blue plug at fuse/junction block under driver's side dash
This is the driver's doorpin and it rests at ground (-) with the door closed. Use a relay to open this wire which will simulate the door opening and shut down the radio.