2010 dodge nitro

Home / the12volt's Install Bay / Car Security and Convenience / 2010 dodge nitro (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

fdny136

Member - Posts: 30

Joined: December 14, 2003

Location: New York, United States

Posted: October 26, 2010 at 3:13 PM / IP Logged

install is 2010 dodge nitro. I have a compustar 6200s and blade al for the install.This is the first time I am using this unit for the first time,prior I have used dei products mostly 561 valet and key in box .anything special I need to use for this install? do I need all the wiring or just the main power ign harness and can wires? thanks so much

Back to Top

kreg357

Platinum - Posts: 7,783

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 30, 2009

Location: Pennsylvania, United States

Posted: October 26, 2010 at 5:38 PM / IP Logged

From the Compustar, connect power, ground, hood pin, parking lights (right & left with 8 Amp diodes ), horn and ignition ( thru the 5 Amp fuse ). If it is a manual transmission, you will have to bypass the clutch. The blade connector has the three connections shown. Most everything is done thru data via the CAN bus.

Make sure you flash the CH5 firmware onto the Blade AL. While you are at that iDatalink screen you can also set any Compustar programming options needed.

Soldering is fun!

Back to Top

fdny136

Member - Posts: 30

Joined: December 14, 2003

Location: New York, United States

Posted: October 27, 2010 at 10:51 AM / IP Logged

i have the unit installed as described ,does the compustar have a nuetral safety? as the door locks and parking lamps work but car will not crank? also can bus h on my vehicle is white black not white light green at immobiliser.does the starter wire from 6500 get tied in? thanks

Back to Top

fdny136

Member - Posts: 30

Joined: December 14, 2003

Location: New York, United States

Posted: October 27, 2010 at 11:01 AM / IP Logged

nvm thanks just had to program tach

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2010 dodge nitro

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.