clifford 590.2x and dei dball

Yes, I used the Bitwriter to confirm it was in automatic trans mode. The neutral safety is grounded. The toggle switch was tested with a meter and plugged into the module and turned on. There are no chirps to tell me what's going on (like 7 for manual trans) it just acts as if it's starting and the remote says the vehicle is running but I don't even hear any relays clicking in the module. Even the parking lights come on a few seconds after initiating remote start. But the ignition does not come on and the starter never engages.

Hi Dunce-cap I hope you solved all your installation issues,I just purchased the 590.2x, and the only documents I was able to get was the directwire info for my vehicle and the installation manual which does not come with the unit, could you please share any tech sheet information about the installation of this unit? I've done this kind of work before and what info I have here is not enough information, their has to be more info pertaining the install for this unit....Anything you can do, I would so appreciated!

Dunce-cap did you ever figure out your remote start problem? I have the exact same issue in an 01 silverado with the clifford 590.2x where it turns the truck accessories on during the remote start sequence and not the starter without showing any codes. Thanks