viper 5901

dasbogie provided you with the answer you are looking for. Download the install manual for the Viper 5701, starting on page 60 are the instructions on how to access the menus with out a BitWriter.

Pay attention to the "note" on page 61. 

Page 65 has the menu you are dealing with.    Menu 3, Item 1, Option 2.

It takes some practice, so don't give up.

Key on, then off.  Press and hold the valet button until three flashes and chirps, then release, the press and hold, should get one chirp,  press the unlock button, should get two chirps, (automatic mode), release and wait until system times out, (Horn honk) if connected. Should be in auto mode

Also do you have the Neutral Safety wire grounded?  And the toggle switch plugged in and ON?

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

toggle switch is plugged in and on, neutral safety is grounded. ive tried many times but cant get the led to flash 3 times and cant get 3 chirps. when i press unlock i do get 2 chirpsIan Adams

Make absolutely sure the green door trigger wire is going to ground when a door is opened temporarily ground it if you have to. As we've all said, you need patience, the first time I did one I actually had to call tech support I was so angry with it.

so after a few more attempts i finally got it into auto trans mode :) now when i hit the start button the remote says remote start on and the dash lights come on and everything seams to do what its suppposed to except the truck still wont start. when i push the start button again the remote says remote start off and everything shuts off. it will start with the key turned on.Ian Adams