2006 pontiac vibe ignition wire

hello, I have an alarm and have put its ignition wire on the BLACK/ white ignition wire"S" on the ignition pin. Are there supposed to be two wires? it doesn't look like their working either, since i can't get into programming mode and the fact that my car is turned on or off is ignored by the alarm.

laserbeak43 wrote: hello, I have an alarm and have put its ignition wire on the BLACK/ white ignition wire"S" on the ignition pin. Are there supposed to be two wires? it doesn't look like their working either, since i can't get into programming mode and the fact that my car is turned on or off is ignored by the alarm.

I only saw '07 listed here so I pulled the following from Code Systems website. 2006 Pontiac Vibe       Battery         BLACK      (+)        IGNITION SWITCH HARNESS           Ignition 1 BLACK / YELLOW (+)     IGNITION SWITCH HARNESS      Ignition 2 BLACK/ WHITE (+)     Ignition Switch Harness Accessory 1 BLUE/RED     (+)     Ignition Switch Harness      Starter 1   RED          (+)     IGNITION SWITCH HARNESS You should probably test the wires before hooking them up to ensure you are using the right one. Looks like you have 2 ignition wires and you're currently hooked up to ignition 2.

Hi, Thanks for your reply, and sorry mine is so late, but the two ignition wires are both black and white, the white stripe on one, is smaller than the other though. I've tried the BLACK / YELLOW one, had no effect. I'll let you know if i can figure it out. Thanks

oh that was the right one, the taps i were using were too big for that particular wire. Thanks

TAPS? Blasphemy ban this person from the site! SOLDER and Scotch 33+.

howie ll wrote: TAPS? Blasphemy ban this person from the site! SOLDER and Scotch 33+.

i hear you, the connections feel flimsy.