2011 lincoln mk s rem start

I recently installed a remote start into a 2011 Linc MK-S with a OL-MDB-ALL with FM v1.3 firmware but I have two problems: The car will not start when any of the doors are open (tech support-OMEGA_LINK says its not their unit causing this) and the car WILL start every time but it takes literally 24 seconds to start the car. Any help??thetopinstaller

How did you wire everything ? I've done a bunch of these with both the ford add on starter and dei stuff.   There is a yellow/orange wire at the start switch it's a negative trigger that will start and stop the car   Also you need to isolate the brake wire so the car sees the brake signal but the starter doesn't   Also I use dei 1101T. So I can't help you with your bypass but I've noticed I depends on placement of the module under the dash whether the car gets the signal right away or notIf i Can't Install it    I Don't need it   Joe

I uploaded a .pdf document detailing how I hooked it up. And yes I used the yellow orange wire for start.thetopinstaller

where did you upload the file to ?If i Can't Install it    I Don't need it   Joe

I guess it didn't go thru-I'll try again----I havent been able to figure out how to attach a doc yetthetopinstaller