2006 mazda 6 factory alarm/ disarm 451m?

Im getting ready to prewire a remote star for a mazda. I plan on using the dei 451m Does anyone know if the factory alarm disarm wire will also unlock / lock the vehicle or will i have to wire up additional relays for that too? Also i believe this is a negative multiplex system, and i just wanted to confirm that i will be usin diagram h located in 451m manual https://www.the12volt.com/installbay/file.asp?ID=726 Any input os appreciated thanks -rob

there is a blue wire in the driver kick white plug that will disarm and unlockAdvanced

Perfect, do you know what value resistor i need? Or is itna straight pulse?

Bulldog lists a green wire which i did not test for as I didn't need doorlocks, just disarm but it is in the same plug.  They list 1k ohms to lock and straight ground to unlock.  The blue wire I used was straight groundAdvanced

Directechs says Lt green is the lock/unlock wire . It does not mention about the doors unlocking with factory arm/disarm. Directechs lists Blue or blue / white as factory arm/disarm. Again this does not state that it actually unlocks/locks the car. Can anyone confirm that there is a wire that will unlock/disarm, and lock/arm? Or should i just wire up two more relays for the factory alarm/disarm wires ?

ON a second note ive done some searching that the blue/white wire can be used for factory alarm arm/disarm along with lock/unlock when triggered thru a 750 ohm resistor.