the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2010 volkswagon eos wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
jzzaremba83 
Member - Posts: 2
Member spacespace
Joined: December 22, 2010
Location: Illinois, United States
Posted: December 22, 2010 at 11:36 AM / IP Logged  
trying to install remote starter and keyless in 2010 volkswagon eos. Haing problems with lock and unlock and finding a tach wire. thanks
i am an idiot 
Platinum - Posts: 13,670
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: December 22, 2010 at 11:44 AM / IP Logged  

One wire system, apply ground through a 250 ohm resistor to unlock.  Apply straight ground for lock.

2010 volkswagon eos wiring -- posted image. Power Unlock BROWN / GREEN (-) AT DRIVER DOOR MODULE IN DOOR 2010 volkswagon eos wiring -- posted image.
2010 volkswagon eos wiring -- posted image. PowerLock BROWN / GREEN (-) AT DRIVER DOOR MODULE IN DOOR

mustyk@att.net 
Copper - Posts: 132
Copper spacespace
Joined: November 25, 2009
Location: Michigan, United States
Posted: December 22, 2010 at 9:19 PM / IP Logged  
FL-CAN module should have lock/unlock ability as well as provide tach signal
thetopinstaller
jzzaremba83 
Member - Posts: 2
Member spacespace
Joined: December 22, 2010
Location: Illinois, United States
Posted: December 23, 2010 at 5:39 PM / IP Logged  
put in fl-can piece and got door locks and trunk to work but not tach . Is there a special way to get tach to work. parking lights just flash as if tach wasnt programed
mustyk@att.net 
Copper - Posts: 132
Copper spacespace
Joined: November 25, 2009
Location: Michigan, United States
Posted: December 23, 2010 at 9:18 PM / IP Logged  
Check the tach output from the FL-CAN with a high impedance test light (L.E.D. style) to see if its even working. You should see a flickering light that speeds up with acceleration.  I would clamp a Hi-impedence test light to constant power and test the FL-CAN output. If it works then theres something wrong with the tach Learn sequence.
thetopinstaller

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, May 5, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer