06 trailblazer remote start problem

Home / the12volt's Install Bay / Car Security and Convenience / 06 trailblazer remote start problem (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

cinjo

Member - Posts: 2

Joined: January 08, 2011

Location: Pennsylvania, United States

Posted: January 08, 2011 at 5:30 AM / IP Logged

Hi everyone, another remote start problem. I installed a Bulldog RS 82 with a PLJX bypass in my 06 TB. Wired everything up exactly as the directions called for but I have 2 problems no one can help with. Of course I can not get any response from Bulldog either.

1. When remote starting, vehicle will start for a second or 2 then shut off. It will do this 3 times and stop.Is this a tach problem (I am using tachless mode), Passlock II, or something else?

2. When programming with the Bulldog remote, brake applied and stop button pressed, the starter engages for a second every time.

I have installed a few remote starts before , even installed the RS82 in my 99 Tracker last month with no problems. I just can't seem to get this one.

Any help is appreciated and thank you.

dasbogie

Silver - Posts: 514

Joined: September 30, 2006

Location: Pennsylvania, United States

Posted: January 08, 2011 at 7:41 AM / IP Logged

run a tach wire, you can get it inside the car

Advanced

kreg357

Platinum - Posts: 7,787

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 30, 2009

Location: Pennsylvania, United States

Posted: January 08, 2011 at 7:47 AM / IP Logged

Did you get wire up a relay and power the ACC2 wire?

Soldering is fun!

cinjo

Member - Posts: 2

Joined: January 08, 2011

Location: Pennsylvania, United States

Posted: January 08, 2011 at 9:19 AM / IP Logged

The acc 2 wire is connected but there is no relay. I hooked up the tach wire this morning and now it wont do anything at all. I think will just take it out. I can only take so much.

reecegr

Member - Posts: 28

Joined: November 24, 2007

Location: Wisconsin, United States

Posted: January 08, 2011 at 10:07 AM / IP Logged

ADDENDUM

If you have an RS1100 or RS1200 and your vehicle runs for several seconds, shuts off, restarts, runs, and shuts off again, perform the following step: Connect the BLACK/ White tach wire (from the 16 pin plug) to the heavy gauge White Ignition 1 wire and program the unit for Tach Mode (bottom of page 19).

from bulldog website,i see its not your model byt worth a try

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

06 trailblazer remote start problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.