the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

need astrostart antenna?


Post ReplyPost New Topic
< Prev Topic Next Topic >
chevyman14 
Member - Posts: 22
Member spacespace
Joined: December 01, 2010
Location: Minnesota, United States
Posted: January 24, 2011 at 7:36 PM / IP Logged  

I went and took a look under the dash and there are alot of wires that are not hooked up. if you are looking at the unit with the harness towards you it is the harness on the right.  I did check out the wire for the antenna and it looks ok at the brain. Also when I start it the red LED flashes really fast. I did not see any modual under there anyplace.

Were is the wire for the OEM hood pin?

If I know were the wires are and what ones I need to hook up I have no problem trying to hook things up.

How much are those moduals that you said are needed for the doors?

The antenna is mounted right behind the rear veiw mirror down about 5-6 inchs from the top

monty_77 
Copper - Posts: 491
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: January 15, 2009
Location: North Dakota, United States
Posted: January 24, 2011 at 8:20 PM / IP Logged  
the flashing led when start is normal it just the tach signal.
send me an email in a PM or email me and i will send you the wire references with pic make it easy for you.
also if you tell me the color of the wires not used i can help you with that and what they do it is on the back of the Brain
as for the xk03 module it 20 dollars on ebay but will need to be flashed with chdl6 firmware and you will need two 1-amp diodes
if you go this route check that they will flash it with the right firmware before buying.
it's not that hard to just use resistor. you can get them at radio shack for like 5 bucks
i do advise to solder the connections too. if you don't have an iron you can get one for under 10 bucks that will work for this one install. just fine i would advise a 25 watt at least.
The mount for the antenna should be fine just wanted to make sure it was in a good location.
chevyman14 
Member - Posts: 22
Member spacespace
Joined: December 01, 2010
Location: Minnesota, United States
Posted: January 24, 2011 at 8:26 PM / IP Logged  

pm sent

Thanks

Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, July 13, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer