python 872 10 pin connector exptd got 8

Hello everyone! So I purchased a Python 872 from GoodDeals18, just got it in the mail today and was quite happy. After further investigation I noticed a few things wrong. The first is that there is a heavy gauge wire connector that is only 8 pins, But the main box requires a 10 pin (the 8 won't fit at all...). The second thing is that mine unit looks quite a bit different from the install guide on this site for the Viper 5701. By different I mean, that some of the connectors are in different spots and instead of having 3 connectors they are combined into 1 18 pin connector (although it only uses 17 pins)... It also looks much different than this: newegg python 872 I emailed gooddeals18 asking them about it, but doubt they will know anything. Has anyone else bought a python 872 and had similar issues?

So they did include the wrong cable, I was sent a replacement cable. Although I still cannot find an installation guide for the exact model that i have only the similar viper 5701.

The 18 pin harness combines three wiring harness from the older 5701, (872, Clifford 3.3x).  The H2, 8 pin connector, the 5 pin remote start input, and the  Remote start auxiliary output, 5-pin, also the horn honk at the H2/8 position.

In the downloads section of this site find the chart for the viper 5901 lc3 quick reference install guide. Should match your wiring.

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Funny.... ordered the same one about a month ago from the same place and when I went to install it I also had the 8 pin connector. I emailed them and they shipped one out the same day... Ive been searching the web for the actual install guide and found this.

http://www.scribd.com/doc/56277292/5701