99 jeep cherokee 2 way alarm

Home / the12volt's Install Bay / Car Security and Convenience / 99 jeep cherokee 2 way alarm (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

elmigraman

Member - Posts: 3

Joined: July 29, 2004

Location: Arizona, United States

Posted: August 05, 2011 at 8:24 PM / IP Logged

Good evening everyone,

I just purchased a two way Performance Teknique 2 way car alarm ICBM-7071, and I am about to attempt to install it. I am somehow familiar with electronics and this forum has provided a wealth of knowledge over these years. I searched for a tutorial to install this alarm, but I did not have any luck. Can anyone provide a step by step as to how install the alarm? For instance, I do know how to take apart the ignition switch and test wires for voltage. From there, I am lost since I do not know where is the 99 jeep cherokee factory door module, or if the door locks are negative or positive triggered (how do i test for this?), vacuum type, reverse polarity, etc? I know that I am asking for too much, and that this alarm is very cheap, but is all I could afford now. All the help is greatly appreciated.

I attempted to install a starter kill switch, but after reading here, I am not sure if I need a relay with a diode or not. I was trying to put the switch inline with the brown small gauge wire that goes to the starter (I believe it comes from the ignition). But I did not know if a relay is needed. Please help.

I posted a link to the diagrams, and that is all it came with the alarm. As you can see it is pretty generic and useless for the noobs like me.

https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0003.jpg

[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0001.jpg[/IMG]

https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0004.jpg

[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0004.jpg[/IMG]

https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0001.jpg

[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0003.jpg[/IMG]

Very respectully,

Joe

elmigraman

Member - Posts: 3

Joined: July 29, 2004

Location: Arizona, United States

Posted: August 16, 2011 at 10:40 AM / IP Logged

Please...Can someone help me? I would like to do the installation on my own. At least can someone provide enough information to get started?

Thank you,

Joe

casofwaco

Member - Posts: 26

Joined: October 15, 2008

Location: Texas, United States

Posted: August 16, 2011 at 11:45 AM / IP Logged

99 jeep cherokee 2 way alarm -- posted image.

Battery

PINK/BLACK

(+)

Battery	PINK/BLACK	(+)	IGNITION SWITCH HARNESS
Ignition 1	BLUE	(+)	IGNITION SWITCH HARNESS
Ignition 2	BLACK/ ORANGE	(+)	IGNITION SWITCH HARNESS
Accessory 1	BLACK/ WHITE	(+)	IGNITION SWITCH HARNESS
Starter 1	YELLOW	(+)	IGNITION SWITCH HARNESS
Anti-Theft Type	DAIMLER SENTRY KEY® VEHICLE IMMOBILIZER
Anti-Theft Descript	THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense	PINK/LIGHT BLUE	(-)	IGNITION SWITCH HARNESS
Neutral Safety	YELLOW	(+)	IGNITION SWITCH HARNESS
Tachometer	GRAY	(-)	AT IGNITION COIL
Parking Lights	BLACK / YELLOW	(+)	AT VEHICLE LIGHT SWITCH
Brake Lights	WHITE/ TAN	(+)	AT SWITCH ABOVE BRAKE PEDAL
Reverse Lights	BROWN / LIGHT GREEN	(+)	IN HARNESS IN DRIVERS DOOR SILL

BAD Boy Emergency Vehicle Lighting

casofwaco

Member - Posts: 26

Joined: October 15, 2008

Location: Texas, United States

Posted: August 16, 2011 at 11:50 AM / IP Logged

All Door Trigger	YELLOW	(-)	IN HARNESS IN DRIVERS KICKPANEL
Trunk Trigger	TAN/BLACK	(-)	AT LIGHT IN TRUNK
Parking Lights	BLACK / YELLOW	(+)	AT VEHICLE LIGHT SWITCH

	Power Unlock		PINK/VIOLET		(-)		IN HARNESS IN DRIVERS KICKPANEL
	PowerLock		ORANGE / VIOLET		(-)		IN HARNESS IN DRIVERS KICKPANEL

Trnk Release

PINK/BLACK

(+)

IN HARNESS IN DRIVERS KICKPANEL

I hope this helps some

BAD Boy Emergency Vehicle Lighting

elmigraman

Member - Posts: 3

Joined: July 29, 2004

Location: Arizona, United States

Posted: August 16, 2011 at 10:45 PM / IP Logged

Thanks a lot. I will start working tomorrow on this project. I am kind of nervous because it will be my first alarm install.

Thanks for the help!

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

99 jeep cherokee 2 way alarm

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.