1996 bmw 318i remote starter .

Hi, i bought a astro start rs 613 to install into my '96 bmw 318i.. i hooked up all the wires but cannot get it to autostart. can someone help me with the setup process? what i'm doing wrong. thanksvan5661

Tach, thin black pin 9 to OBD ll (data connector) or plug at rear of instrument panel. By-pass, if key in box type, e.g. 556U ONLY use the grey valet key and wire it Euro style without the loop. Vehicle ACC purple (violet) needs to be wired as 2nd. ignition, don't connect the unit's ACC output.

I did everything that you listed above. Do I need to hook up the H11 Programmable Relay? If so, where does it go? Does the H3 Programmable Outputs need to be hooked up or not? The 'yellow' Pulse Start Input where do I hook that up to?van5661

I haven't a clue since I only know the car not the R/S. If you did what I suggested and it still doesn't work check your wiring. Programmable outputs, only a timed, 10 secs. or 15 with electric roof linked to your lock wire to activate on arming to close your windows and roof (where applicable).

it may have chip on keycubanthug

Which is why I mentioned the 556UW earlier.

Astrostart 613 this is how i hooked up the wires. red input to 12 volt ignition RED / black input to 12 volt ignition orange output to green ignition yellow output to pink accessory green output to tail light BLACK/ grn to tachometer blue start output to start green output when running transponder 556U (key inside the box) red to 12 volt black to ground blue to remote start green when running Is this wiring correct? The LED keeps blinking error 14. Why can't I program level 1 and level 2? Can anybody help me with this problem? Thanksvan5661

What are the Astrostart colours for, in particular the yellow output. Incidentally the vehicle's ACC isn't pink it's purple or violet, also please give me the vehicle colours you wired to.

OK while I'm waiting for the Astrostart colours let me say something. The mods keep on downgrading me for flaming people but I have to say this. You haven't done what I asked you to do in my first post, although in your second you said you had. What have you done wrong? The clue is in the yellow wire.

Prior to the initial post I have already set up the 556U. Sorry I was seeing purple but wrote down pink. Astrostart 613 wire colours: red -12 volt input RED / black -12 volt input orange -ignition output yellow -acc output blue -start output Vehicle wiring from key: red-constant 12 volt green -ignition 2 purple-acc BLACK / YELLOW-starter wire And this is how I hooked up the wires: (astrostart) red & RED / black wired to (vehicle) red (astrostart) orange wired to (vehicle) green (astrostart) yellow wire is not hooked up yet to (vehicle) purple (astrostart) blue wired to (vehicle) BLACK / YELLOW Astrostart small yellow wire pulse input (-) wired to trigger behind the glove box 12 pin plug AUX output (-) not hooked up Astrostart white wire for programming relay is not hooked up 'cuz I don't know where to wire it to. I have the programming manual but still cannot program the starter. The LED keeps blinking error code 14. All the Astrostart wires for power lock/unlock is all working. van5661