viper 5101 in a 2002 jeep liberty

Thanks ill try it and let u knowford is the best

So we got some of the wires hooked up last night after school now we came in to a problem I think on are 8 pin connector there is a starter out put and a fused starter input what do we do thou them do we cut the starter wire and soder the starter out put going to the motor and soder the starter input going to the ing? And there is 4 ignition wires ING 1 imput/output pink.     ING. 2 RED / white 30a fused flex relay input 87 ING 1 red input fused 30a      ING 2 pink/white flex relay output. Where do all these go if there is just 1 ING wire   and for now just one more? What do we do about residor how do you put them in for the door locks. Thanks againford is the best

ok, im going to tell you were you need to hook them up, 1st. RED / white wire is not used 2nd. pink wire goes to RED / blue IGN1 in vehicle 3rd. pink/black not used 4th. pink/white goes to BLACK/ white 2nd accessory in vehicle (make sure you programmed this wire, it requires programming for second accessory.) 5th. orange wire goes to BLACK/ orange 1st accessory in vehicle 6th. RED / black wire goes to red(+) power on vehicle 7th. violet goes to yellow starter on vehicle(no need to cut, unless kill switch being installed in vehicle.) 8th. red wire goes to red(+) power on vehicle. That should complete your 8 pin connector, hope this helps if any more questions let me know. You can also look at pages 24 and 25 from your installation manual, that should help you.im ( J ) and car audio is my thang.. and if i can help i will.