remote start, 2000 chevrolet silverado

Status Update: Tach hooked directly to injection coil, tach learned successful Vehicle continues to immediately die after start attempt

Any ideas on troubleshooting the XK09. It programs just as expected, but how can I tell it's actually working? I would like to post a picture of my setup, can we post pictures on this forum?

I hope this helps, please tell me what other pictures would help.

The left picture is the XK09 pin 10 to ORANGE / black passlock ground The right picture are the XK09 Resistor Code Outputs to yellow passlock wire.

Your scotch lock connectors could be the issue... try stripping the wire and make a good wire to wire connection.. then try to relearn the Passlock...

Removed connectors and reprogrammed XK09, no dice.

ITS ALIVE!!! Bad ground and mux wires not connected on XK09. Thank you to everyone that took time to help me out. This is a great resource that I will definitely use in the future.

Good news!  Check your PM for an important bit of info.   Soldering is fun!

Not working now! After I got it working I was soldering all the connections to finalize the job and now it's just acting crazy. The RS works without the key, but won't start with the key. Oh, and the RS works with the bypass unplugged...wth! I think as I was soldering the connections I tripped passlock and now it's all screwed up. I can't get a flashing security msg to reset passlock. Disconnected battery for over an hour...no luck. Solid security msg and check engine soon light displayed when attempting to use key. I don't want to even try to drive the truck in fear of screwing up the transmission. Please help!