2000 toyota avalon python 1401

Same as Viper 5101. 1) I attempted to install it earlier, I failed. The car did not start or crank it just flashes 7 Times which mean the manual mode is active but I wire the neutral safety wire to ground. or I have to program it to Automatic mode? if yes, How do I program it? 2) the H3 harness, I used all of them. Should I be using all of them? If I don't, can someone provide me the details on what and where to connect the wires? H3/1 PINK IGNITION 1 INPUT/OUTPUT H3/2 RED / WHITE (+) FUSED (30A) IGNITION 2 / FLEX RELAY INPUT 87 H3/3 ORANGE ACCESSORY OUTPUT H3/4 VIOLET STARTER OUTPUT H3/5 RED (+) FUSED (30A) IGNITION 1 INPUT H3/6 PINK/WHITE IGNITION 2 / FLEX RELAY OUTPUT 30 H3/7 PINK/BLACK FLEX RELAY INPUT 87A key side (if required) of FLEX RELAY H3/8 RED / BLACK (+) FUSED (30A) ACCESSORY/STARTER INPUT 3) How do I program the PKALL correctly? 4) What are the minimum requires just to test the remote start? ( H3,H1, and neutral safety hooked up or more?)

neutral safety needs to be grounded, the toggle switch (if it has one) needs to be in the right position, and automatic transmission needs to be programmed. I believe on the new DEI junk that all the units are default as manual trans. I'm not 100 percent sure on how to program those units, its been a while, but it should be in the install manual. What is up with the12volt.com forums and DEI? I guess thats why there's always posts on these products...not user friendly and full of bugs. Sorry to rant on your post.I drink current, eat ohms, and bleed voltage

Program remote starter for automatic, Default from company is manual transmission,Check the safety switch is in the right position.