2005 equinox bypass and?

Here's the update:

Installed a Clifford 20.7x (Viper 5501), with a DB-ALL, firmware GM5, Installation Type 6.  Went with W2W mostly because of all the issues I have read about going D2D. Real nice bypass as it took care of the door lock/unlock and tach.  Programmed first time with no issues.

Easy to get at the ignition, lots of room under there. At least for me. I'm not a huge guy. Taking the center counsel apart was a bit more work.

Bench prepped the unit and the bypass. First time to do that. Seems like I didn't have the usual spaghetti mess of wires afterwards.

Kregs notes were right on as to location and color for wires. Your info and guidance was much appreciated. There is a six pack of beer on the way to you. LOL

Only thing that threw me was after I connected the ignition, Acc, Acc2, 12 volt constant(2x), keysense, and the R code wires, I tried to start the vehicle with the key to make sure it would still start, it would not. Keep getting a flashing car/lock symbol on the dash. Even though I had not connected any power to the DB-ALL.      

I disconnected all of the harness, and still no start.   So I programed the DB-ALL, and then it would start with the key again. Not something I was expecting. Only had a small coronary over that.

Once again this site is amazing.  For all those that find this site helpful, Please Donate.

Thanks for the update.   Think you'll find going W2W and bench prepping make life much easier ( and neater ).

That's good news with the DB-ALL working properly and doing everything it's supposed to.     Now if only D2D would work consistently...