viper 5704 led pulses while driving

The pink ignition wire is a 2 way wire and needs to be hooked up even if the relay isn't working. The sense should be after the relay so it can sense the ignition power from the key. You can't change settings or add and delete remotes if it's unhooked. Which is why the unit isn't resetting the trigger indications. You could also replace or have someone replace the relay as it is a through hole PCB type soldered to the circuit board. Just need to follow the copper trace to the relay and google the part numbers to get the right one.

Hi, I do believe I kept the pink wire hooked up still. I will check tommorrow when I hook up the scanner. Thanks

I just took a look and i have a relay set up as such: 85-wire connected to -200ma 2nd status blue/white defog wire 30-wire tapping into hooked up viper pink ignition 1 wire on remote start harness 86-looping wire to 87 87-wire tapping into red viper fused ignition 1wire on remote start harness LED still blinks last triggers in pulses while disarmed and driving

Did you inspect the board to see if the relay failed or if it was a bad solder joint? If you do open it up and it is a solder problem it's easily fixed. Check where the pink pin goes to the board.

I would hate that because that daggon light is bright!! lolWhen in doubt....kick it!