iluminated entry 04 chevy silverado

I recently installed a viper 5704 on a 04 silverado, i noticed that when the truck is running with the remte start and i unlock it the iluminated en =try does not come on like when the truck is not running, reverse light and DRL dont come on!is there some thing that i could do to make it come on when running?it has a DBALL

And also i noticed that my temp reading is alwayas at 86! dont know why.did i miss a wire tobe connected to the temp sensor??thank you!!

pvc

Please list your Viper H3 harness connections.  Soldering is fun!

Here s h3 connections; h1pink ignition 1 to pink h2red white ignition 2 to constant 12 volt h3orange accesorry to orange h4violet starter output to yellow starter h5green starter input to yellow staterkey side h6red ignition 1 input to 12 volt constant h7pink/white ignition 2 to white h8pink/black flex relay to none h9red black accesory to 12 volt constant pvc

They look good.  Not sure if it matters much on that truck but there is a Brown ACC2 wire.

Might try reprogramming the DB-ALL ( don't use them ).  Next would be going to W2W ( if you're D2D now ) and as a last resort a call to Directed Tech Support.

Soldering is fun!

So the iluminated entry should come on when runnig??how about the H2 harness ,any connections that i mtight of missed on that? also how about the temp ?any thughts on that?pvc

Not sure on your 2004 Silverado, haven't done any for a while.  Most vehicles will turn on the interior lights with an unlock while the engine is off but not while it is running.  You could try connecting the Vipers' Dome Light Supervision wire.

Dome Loght Supervision info from various sources ( they do conflict, so test ).

From Bulldog Security :

DOMELIGHT SUPERVISION   GRAY/BLACK (-)    @ BCM, BLACK PLUG, PIN E, SEE NOTE #3 NOTE #3: The BCM is located under the Drivers Side of the dash, the BCM has 6 plugs on it,         with the PURPLE plug on the back.

From ReadyRemote :

Dome Supervision  gray/black (+)     @ BCM, black plug, pin E

From AudioVox :

Domelight Super  USE ONE DOOR TRIGGER  (+)  IN HARNESS AT VEHICLE DOMELIGHT

From Omega :

Dome Light      DR (-) GY/BK,PAS (-) BLK/WHT       AT BCM (BLUE 24 PIN CONN) *

Viper:

H2/7 BLACK / YELLOW (-) 200mA DOME LIGHT SUPERVISION 0UTPUT

The Temp Gauge problem is strange.  Are you sure it wasn't happening before the R/S install?

Soldering is fun!

Thank you Kreg! ill connect the domelight! About the temp gauge ,i did not notice until i was done with the install. since at day time it was around 86 i thugth it was normalpvc

There is a proceedure to re-calibrate those mirrors. I did it one time for a friend.. Google it, I am sure you will come up with the procedure...