DIRECTWIRE™ WIRING INFORMATION - TOYOTA / AVALON / 2001 / Remote Start
[PRINT THIS PAGE]
12volts wh/blu (40A), wh/red (10A) + ignition harness
Starter BLACK/ white + ignition harness
Second Starter N/A
Ignition BLACK/ orange + ignition harness
Second Ignition WHITE/ red + ignition harness
Third Ignition N/A
Accessory WHITE/ green + ignition harness
Second Accessory N/A
Keysense RED / yellow - ignition harness
Notes: Using the status output wire from the remote start to ground this wire will disarm the alarm without unlocking the doors.
Power Lock see Tech Doc 1070
Power Unlock see power lock
Lock Motor blue/red 5wi right side of the fusebox
Unlock Motor blue/white 5wi right side of the fusebox
Parking Lights+ use (-) wire only
Parking Lights- pink - steering column or BCM
Notes: The BCM (Body Control Module) is attached to the bottom of the fuse box.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger RED / blue or red - right side of the fusebox
Dome Supervision GREEN/ red - driver A pillar
Trunk/Hatch Pin red - left side of the fusebox
Hood Pin black - theft ECU
Notes: The theft module is located above the glovebox.
Trunk/Hatch Release blue - switch on dash
Notes: Only works if main switch in the glove box is on.
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock use key sense wire
Tachometer black ac driver kick panel
Notes: Located in a gray plug, with the wires going up to the instrument cluster.
Wait to start N/A
Brake Wire RED / blue or GREEN / WHITE + brake switch or pass. kick
Parking Brake
Horn Trigger GREEN/ black - steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Door Lock Interface Required:
No Type:
Data Bus
Part #: IM-Toyota-2
Notes:
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 1100X
Alternate Part1 #: DesignTech 29402
Alternate Part2 #: 1100F
Alternate Part3 #: 555XW
Alternate Part4 #: 556UW
Alternate Part5 #: DesignTech 20402
Notes: The synch wire is blue / YELLOW, clock wire is blue/orange, data wire is pink/green, ignition wire is BLACK/ white, and ground wire is WHITE/ black. When using the 1100F, a software change to 1100TL is needed.
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.