avital 4103 rs and pkall immobilizer

Im installing an avital 4103 remote start on a 1998 ford explorer using the express pkall module and cant seem to find where the blue/white wire on pkall module hooks to the avital unit. The manuel for express kit says to hook to (-) while running wire of avital unit but not sure which wire that is. Also the xpress module wont program, I get to step 8a which is programming for auto trans which says - press and hold the programming button untill the led flashes once, then release- but the led never blinks, if I let go of programming button the led comes on and stys lit. Any help is greatly appericatedbill

Either satellite harness, pin 1 blue or H3 Blue/white labelled either GWR or "status output", 2nd. question, check your wiring and re-read the instructions.

I read that step 8a is activate the remote start is automatic.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

It's not the Xpress module it's the 4103 that won't program.

Thanks for the info ill recheck my wiringbill

Ok have the blue/white wire correctly but another question the pink wire says to wire to ignition of vehicle, would that be ignition wire in switch for tumbler or ign wire at column? Thanks again for the helpbill

The PKALL Pink wire can connect to the Avital 4103 thick Pink Ignition wire ( that continues to the Explorers GREEN/ Purple Ignition wire ).Soldering is fun!

By definition:- Ignition wire 0V on key out. 0V on ACC. 12V on ignition. 12V on start. The wire that runs from the IGNITION SWITCH to various circuits enabling the engine to be started.

Thanks again for all the help, its been a couple years since doing any install so im a little rusty, just do it to help out freinds and family anymore so sorry if any questions seem repetious or lack of common sense.bill