the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2003 honda accord head unit


Post ReplyPost New Topic
< Prev Topic Next Topic >
supradude 
Silver - Posts: 915
Silver spacespace
Joined: September 21, 2004
Location: South Carolina, United States
Posted: April 17, 2013 at 4:28 AM / IP Logged  
I need some help to install a head unit in this accord. Can someone tell me where all of the screws, ect are?
'85 Toy
soundnsecurity 
Gold - Posts: 2,711
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: November 10, 2008
Location: Louisiana, United States
Posted: April 17, 2013 at 7:54 AM / IP Logged  
not sure exactly what the 03 accord looks like but i can tell you with a good degree of certainty that there will be two screws holding the radio from underneath. you will have a panel to remove under the radio and the screws should be towards the back of the radio facing up.
if this is the accord with the compartment unde the radio with the door that flips open then i think you have to remove the panel around the shift knob first, then there could be some screws holding that compartment down. once you get those screws the compartment should come out allowing you to get to the screws that hold the radio in.
dont pry on the radio with anything other than plastic panel tools or you will damage the soft foam around the radio. i like to use a right-angle pick to get behind the edge of the radio and pull it out like that, that way theres no prying to be done, just pulling.
soundnsecurity 
Gold - Posts: 2,711
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: November 10, 2008
Location: Louisiana, United States
Posted: April 17, 2013 at 7:56 AM / IP Logged  
if this is the accord with the little clock in between the air vents at the top of the radio housing then that clock pops out and theres one screw behind that too.
i just looked at a supposed picture of the radio out of an 03 and it looks like the air vents on top need to come off too, im not sure if there are any screws in it but it should pull towards you and un-snap. if you are in doubt about any of this just look at the dash kit and it will give you some clues and they might even have detailed instructions depending on which brand of dash kit you have.
i am an idiot 
Platinum - Posts: 13,666
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: April 17, 2013 at 8:31 AM / IP Logged  
supradude 
Silver - Posts: 915
Silver spacespace
Joined: September 21, 2004
Location: South Carolina, United States
Posted: April 17, 2013 at 9:09 PM / IP Logged  
Thanks a lot guys. Been away for awhile. Getting back to working a little.
'85 Toy

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer