Alarm Install: 2001 Dodge Intrepid R/T

Looked through and couldn't find the wiring info for this car. I really appreciate any help here, including tips or tricks for this veicle. Also, not sure if it will be a problem, but the car does have an existing keyless/alarm... not %100, but I think its factory. Is there anything I need to do to this? Thanks al lot.

Make:   Dodge Model: Intrepid Year:    2001 This Database Was Last Updated On:    10/7/02 Index #: 2404 Alarm Constant 12 volts RED & PINK/BLACK IGNITION SWITCH HARNESS Ignition 12 volts D BLUE/WHITE IGNITION SWITCH HARNESS Starter YELLOW IGNITION SWITCH HARNESS Dome Light YELLOW (-) AT EITHER KICK PANEL OR BCM * Trunk Pin Switch TAN/BLACK (-) 22 PIN CONNECTOR HIGH IN DRIVER KICK Parking Lamp BLACK / YELLOW (+) AT BODY CONTROL MODULE * Power Lock WHITE/ D GREEN 16 PIN CONN. IN ACCESS HOLE #217** Power Unlock SINGEL WIRE SYSTEM IN DRIVER KICK OR HIGH IN DR. KICK * Body Control Module (BCM) Located Behind Fuse Box. #217- See Single Wire Resistor Door Lock System Diagram. **Door Locks Require +12v Pulse Thru 2.7K Ohm Resistor For Lock And +12V Pulse Thru 620 Ohm Resistor For Unlock. Tach Signal SEE NOTE * AT POWERTRAIN CONTROL MODULE #239 Ignition #2 D GREEN/ RED IGNITION SWITCH HARNESS Ignition #3 BLACK/ ORANGE IGNITION SWITCH HARNESS Accessory BLACK/ WHITE IGNITION SWITCH HARNESS Neutral Safety BLK/WHT OR BRN/YEL (-) AT SWITCH ON TRANSMISSION OR PCM * Brake Light WHITE/ TAN (+) AT SWITCH ABOVE BRAKE PEDEL Reverse Light VIOLET/BLACK (+) AT SWITCH ON TRANSMISSION Rear Window Defrost N/A * Independant Coil System, TAN/PINK, TAN/L GREEN, TAN/L BLUE, TAN/RED, TAN/ORANGE, & TAN/D GREEN. Each Wire Is A Single Cylinder Signal. Powertrain Control Module (PCM) Loacted On Driver Side Front Fender Near Power Distrabution Block. #239 - See Immobilizer Bypass DiagramGood Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt