2005 mazda 6 dball issues

So then the car tries to start or doesn't respond at all when you try to r/s?Advanced

No response at all. After I reset the brain. I can start it a few times. But then it won't allow me to do anything

In the manual there is a sequence listed as shutdown diagnostics. If doorlocks respond via remote command but the remote start command produces no action then I usually use this. You will need the avital to be disarmed/unlocked and the programming button plugged in. Press and hold the programming button, turn the ignition on then off, release programming button, press and release 1 more time. The led on the avital should flash. There is a table for how many flashes equals which variable is keeping the car from remote starting. If the car is trying to start but dies or shuts down after a few seconds then we need to check if the bypass is function and or check tach signal.Advanced

I will hook up the programming button probably tomorrow. But it doesn't start or even try.

I'm not getting anything as far as trouble codes. Really at a loss here

Could you list all of the wire connection you have made from the RS and DB-ALL to the car? It might help give us a picture of what is connected and what might be missing.When all else fails, Read the Instructions

Support the12volt.com Make a Donation