prostart ct 3371 on 04 ford freestar

Hi guys, I am in need for some troubleshooting advice. Have a prostart CT-3371 with an Xpresskit bypass installed on a 04 Ford Freestar. Wiring/programming seems to be done as per instructions and diagrams, but the van doesn't crank. The brake lights come on for a few seconds and that's it. No lights flashing an error sequence. Tried to remote start with the bypass disconnected and the key in ignition. Same scenario. Swapped the r/s for another unit, no change. Any hints? Thanks"Good judgment comes from experience. Experience comes from poor judgment."

-unknown

I can help you but missing information. What is the xpresskit you use and whitch programm sorry for my english loll

Brake lights come on ? Something isn't right could you list out your connections for us. So we can get a better understanding of what's going on.If i Can't Install it    I Don't need it   Joe

The bypass is a pkall (I think). The product number is 0340766. It came pre-programmed for the van. What do you mean by which program? Thanks,"Good judgment comes from experience. Experience comes from poor judgment."

-unknown

Can you give me your installation wirring?

Sorry guys, I don't have the diagrams on hand. Will post ASAP. Thanks"Good judgment comes from experience. Experience comes from poor judgment."

-unknown

I got a bit further. Forgot to cut the yellow wire loop to set it into automatic transmission. Now it starts with the key in ignition. Next will hook up the bypass. Will post if I run into trouble. Thanks"Good judgment comes from experience. Experience comes from poor judgment."

-unknown