98 chev truck power lock problem

Here is my problem, installed a remote starter in a 98 chev pickup (no keyless entry), Autopage 610. The starter part works great. The problem is that both the lock and unlock wires going to the door (not the starter) both rest at -12v and don't change to +12v until the door lock switch is pushed, so if I hook up the starter lock wire and press the button on the remote it blows the fuse. So any easy solution? Or do I have run a bunch of extra wire thru to the door to di it Many thanks Greg

Power Lock L BLUE DRIVER KICK #203 Power Unlock WHITE PANEL ** #202 ** Without OEM Keyless Entry See Note #203. #203 - See Reversal Rest At Ground Door Lock Diagram you will need a couple of relays. look to the left of this post under secuirty then door locks for the diagram....Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Here is the diagram Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Thanks for you help guys, but i've got a couple of more questions 1)anyone know what the wire colors are for the power lock motors? 2) Can I splice in the relays required right by the power lock switch so it will operate both the lock on both doors Thanks Greg

The wire colors are in the first reply to this and if you wire them correctly then it will work both doors because the wire is the same for all of the doors.Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.