spacer spacer spacer spacer

exterior fiberglass work

Post ReplyPost New Topic
< Prev Topic Next Topic >
Member - Posts: 1
Member spacespace
Joined: June 14, 2014
Posted: June 14, 2014 at 12:39 AM / IP Logged Link to Post Post Reply Quote first_timer
I'm working on molding in new taillights on my tail panel that is made out of flexible TEO. I'm updating the taillights on my car so I purchased a new tail panel section that is also TEO. I want to cut out the old taillight section and mold in the new taillight section. What is the best way to do this without it shrinking up and leaving a faint line where I made my cuts? I know there has to be a way to mold everything in that will not cause this issue later on. I don't want this to come back over time.
What materials do I need to use? Thank you
Member - Posts: 23
Member spacespace
Joined: September 25, 2006
Location: United States
Posted: April 04, 2016 at 12:26 PM / IP Logged Link to Post Post Reply Quote digdug18
TEO? Perhaps pictures would help, I can't figure out what exactly you're wanting to do.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Follow Follow on Facebook
Sunday, May 26, 2024 • Copyright © 1999-2024, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo spacer spacer spacer
Top spacer spacer