2013 hyundai elantra gt heated seat

hello guys! i installed a remote starter into a 2013 hyundai elantra gt using a compustar cm7200 module. how can i connect the heated seat into the compustar cm7200 module? what wire should i use from the cm7200 to activate the heated seat? thankstianot

I haven't seen the wiring diagram for this vehicle to see if the power wires can be tapped without issues... Correct me if I'm wrong, judging by photos online, the heated seat switch is a momentary press button built into the center console. You could try this method if your experienced and comfortable with soldering/working on a circuit board. https://www.the12volt.com/installbay/forum_postsm.asp?tid=138044

Absolutely superb attention to detail, you've gone where no one has before except maybe Kreg, Ted and myself

I'm seeing them as being positive triggers in the kick panels, use the defrost POC and a relay to convert to a postive output and test to see if they are pulsed or latched. Driver seat is GREEN/ orange, driver kick, white 43 pin plug, pin 9 Pass seat is BROWN / orange, passenger kick, white 56 pin plug, pin 9