535T window automation

Home / the12volt's Install Bay / Car Security and Convenience / 535T window automation

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

alfa/resto

Member - Posts: 7

Joined: November 07, 2016

Location: California, United States

Posted: November 10, 2016 at 9:48 PM / IP Logged

I'm pretty sure I have it wired correctly using my Spal type switch, relay, and 535T unit. The good part is that I'm not blowing fuses (I have two and using 30 amp in both). However all I get is a click out of the motor. Rather than remove the motor to see if it runs okay, I'm going to wait until the eBay motor arrives next week.

Even if it does run, I have not a clue how to make it work under a load. As I recall when testing the XF with the spoiler installed, I believe the reading was 14.5 volts to the motor and 13.5V for the limit switches. I was unable to get an amp reading today.

Biba

Irwindale, CA

Back to Top

< Prev Page

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.