Ads Alca 2014 rogue

Is a relay needed for this set up?don falkowski

I do not see anything about a relay anywhere in the install guide. What part of it are you thinking you may need a relay to accomplish?

I wasn't hoping to use a relay. I a just at wire end trying to get this thing working.don falkowski

I cannot get the vehicle to crank. The instructions are vague at bestdon falkowski

Your info is also vague. Is it a Rogue or Rogue Select? Is it Push-To-Start or Regular Key Ignition? Are you using a remote starter ( Viper 4105V or something ) or is this a StandAlone install? Which firmware did you flash on the ADS AL-CA? Which Install Type # did you follow in the guide? If using a remote starter, are you going W2W or D2D between them? Might be good to list your connections, too.Soldering is fun!

2014 rogue select. It is regular key start. I am using compustar cs600s. I flashed ADS-AL(TB)-NI4.   I followed type 1 of the installed and flashed the data to data mode. All that is listed for connection in the instructions is what I have connected. I have the data cable attached as well as the immobilizer wires. orange black to white black. Orange to immobilizer. White/red to immobilizer. Pink to ignition. None of the doortrunk/hood wires connected anywhere. don falkowski

Also I have jumper set to accessory position on the cs600 but am not sure if this is where it should be. ADS ALCA green light flashes when trying to start. remote starter clicks, accessories come on, then it shuts off without cranking. Will crank and start with key in ignition and in on position but then shuts off after 3 seconds. I believe the cs600 should be set to tachless by default but I have no way to check that. I get two parking light flashes when it starts the sequence but5 nothing when it fails.don falkowski

As a correction I have ADS-AL(DL)-NI4 flashed. I have purple white connected to tach input on remote starter. green red is wired to brake + output.   brown/red and brown yellow to canh and canl. Actually there are no flashes of light on ads acla when cranking.don falkowski

sorry one more thing..the ebrake output green is not hooked up to cs600 as none of the connections on the remote starter indicate that they are for ebrake statusdon falkowski

falcon73 wrote: sorry one more thing..the ebrake output green is not hooked up to cs600 as none of the connections on the remote starter indicate that they are for ebrake status

Correct, the EBrake would only be necessary for a manual transmission vehicle.Soldering is fun!