the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2000 Chevy S10 Compustar FT-7000AS- Cont


Post ReplyPost New Topic
< Prev Topic Next Topic >
jdmegcoupe 
Copper - Posts: 77
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 15, 2003
Location: Massachusetts, United States
Posted: December 22, 2017 at 10:04 AM / IP Logged Link to Post Post Reply Quote jdmegcoupe
Hello Again Everyone,
So I have a 2000 Chevy S10 manual that I want to install a remote starter and alarm. I got the connections Template from here and filled it out. I am wondering if someone could look it over and tell me if its right or whats wrong in it. I will also include the Wire Color sheets i have for this vehicle..
Thank you,
Dina
2000 Chevy S10 Compustar FT-7000AS- Cont -- posted image.
2000 Chevy S10 Compustar FT-7000AS- Cont -- posted image.
keenxxx 
Member - Posts: 27
Member spacespace
Joined: January 02, 2014
Location: California, United States
Posted: December 23, 2017 at 11:03 PM / IP Logged Link to Post Post Reply Quote keenxxx
I am in the process of installing the same controller in an S-10 Blazer (same wiring). I used the vehicles Red & red/white wire for CS 12v inputs, I have the vehicles pink ign/FI to CS blue, vehicle HVAC orange to CS white, and vehicle white to CS green. I admit I am a little confused about the CS green being can an input / output. I ran the TACH connection to the white wire @ the ignition control module. If you want to trigger both doors you need to diode isolate. Will let you know next week how the system operates when I receive my remotes. I currently have an EZ-GO keyless entry that works fine.
loganemakf 
Member - Posts: 33
Member spacespace
Joined: December 19, 2015
Location: New Hampshire, United States
Posted: December 24, 2017 at 8:29 AM / IP Logged Link to Post Post Reply Quote loganemakf
The green wire on CN1 provides ignition during remote start at which time it is acting only as an output. When the vehicle is not remote started, the controller uses the green wire as an input to see whenever the key is turned to “on”. This is used during remote programming (when you have to cycle ignition on/off 5x) and pit stop mode I believe (probably in addition to a tach signal).
jdmegcoupe 
Copper - Posts: 77
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 15, 2003
Location: Massachusetts, United States
Posted: December 24, 2017 at 9:07 AM / IP Logged Link to Post Post Reply Quote jdmegcoupe
Okay so is the wiring template I posted here correct or not? Thanks for the replies
keenxxx 
Member - Posts: 27
Member spacespace
Joined: January 02, 2014
Location: California, United States
Posted: December 27, 2017 at 1:32 AM / IP Logged Link to Post Post Reply Quote keenxxx
I completed the Compustar install tonight all the wires, as configured, had the system working correctly.
jdmegcoupe 
Copper - Posts: 77
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 15, 2003
Location: Massachusetts, United States
Posted: December 27, 2017 at 7:28 AM / IP Logged Link to Post Post Reply Quote jdmegcoupe
Cool so is my template correct?
keenxxx 
Member - Posts: 27
Member spacespace
Joined: January 02, 2014
Location: California, United States
Posted: December 27, 2017 at 4:52 PM / IP Logged Link to Post Post Reply Quote keenxxx
Your Compustar CN1 connections are using different wires on the vehilce than my connections - same vehicle wires different CS. Your vehilce has 2 different colotr battery inputs red wire and red/white wire. The pink ignition wire is a primary source.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Monday, January 17, 2022 • Copyright © 1999-2022 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer