2003 Chevrotet S-10 starter disable

this is for the 02. double check with a meter Starter YELLOW OR PURPLE IGNITION SWITCH HARNESS Tach Signal WHITE AT IGNITION CONTROL MODULE * Ignition Control Module Is Located On The Passenger Side Of The Engine Compartment.Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

12volts          red       +     ignition   harness      Starter          yellow    +       ignition harness         Ignition        pink         +         ignition harness            Power Lock       lt. blue +         brown plug at BCM         *1 Power Unlock     white         +         brown plug at BCM         *1 Lock Motor       gray        5wi        driver kick panel         Unlock Motor     tan        5wi        driver kick panel         Disarm Defeat    tan        5wi        passenger kick panel         Parking Lights+ brown         +         lt. blue plug at BCM    *1 Parking Lights- white         -         lt. blue plug at BCM    *2 Hazards                             Turn Signal(L)                             Turn Signal(R)                             Door Trigger               -           purple plug at BCM    *3         Dome Supervision               use door trigger                       Trunk/Hatch Pin           N/A                       Hood Pin                       Trunk/Hatch Release       N/A                       Power Sliding Door       N/A                      Factory Alarm Arm                       Factory Alarm Disarm lt. green - purple plug at BCM     *1 Disarm No Unlock    see factory alarm disarm                       Tachometer     white       ac       PCM                         *4 Horn Trigger   black       -       steering column         *5                                  *1 The BCM (Body Control Module) is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the driver side. *2 This wire will not test when using the headlight switch. This wire is triggered by the DRL system. To meter the wire, start the car with the parking brake set, when the brake is released this wire will go to ground. The BCM (Body Control Module) is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the driver side. *3   Use tan for the driver door located in pin B4, orange for the passenger door located in pin B2. Use both wires and diode isolate. The BCM (Body Control Module) is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the driver side. *4   The PCM (Powertrain Control Module) is located on the passenger fender. On the 2.2L the wire is in a black 80 pin plug pin 10, and on the 4.3L the wire is in a red 32 pin plug pin 20. *5   Also found in the brown plug at the BCM on vehicles with a factory alarm. Hope that helps a bit...sorry the notes got messed up...but what can I do... And yes this is for a 2003 s-10