08 TrailBlazer, Compustar RS1B-AL Remote Start

2008 trailblazer LT Compustar RS1B-AL Does anyone have a wiring diagram for this unit for the trailblazer? I have the main wires hooked up, but nothing seems to be working. R/S clicks and thats it. The bypass blade only flashes red led. Any help you can give would be great.

BLADE-AL GM1 CM7200Steve G

Remote start is installed and working correctly.. **Notice** Compustar RS1B-AL from Best Buy (perhaps other places) comes with the "Blade-AL" for integrations and bypass. It is NOT programmed!! You will either need to buy the data cable (ADS-USB) for the firmware, or know somebody that has one. In my case we know a guy from best buy that flashed it for us. This R/S lit right up after the program. As far as the "Nothing is working" complaint from me. I tend of overthink and over complicate things, I'm used to older Remote starts that would take you better part of a day to install and have to spice in 30 wires and 3 relays to get these working. This unit is literally your ignition wires, brake, parking lights, horn and OBDII data wire. A little tip I found on the Parking light wire, Tech bulletin says use the Grey/black wire on back of headlight switch. This is a Neg wire, that would require you to run a relay. Instead if you go back to your ignition wires by the column, By the main connector you'll see a large bundle of wires running one side of the dash to the other. Inside this bundle of wire there is a 12v + "Brown" wire, that is your parking lights. Tap in there from your Remote start and no relay needed. That was actually the hardest part of the install. Thanks fellas.