Issues with Door Locks on CM7000 with Blade in 2017 Ram Promaster

Home / the12volt's Install Bay / Car Security and Convenience / Issues with Door Locks on CM7000 with Blade in 2017 Ram Promaster

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

millerc

Member - Posts: 7

Joined: May 02, 2020

Location: Arizona, United States

Posted: May 07, 2020 at 11:40 AM / IP Logged

Yes the 1k resistors are in place. Although they are 1/4watt and quite fragile so I will have to recheck the connection. Should I consider a higher wattage?

Also I will recheck the lock detection wire since pressing the lock button twice seems to send the lock command to the vehicle twice. I would think that if it could accurately read the lock status it would not try to lock the vehicle after it is already locked.

Back to Top

< Prev Page

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.