2008 Chevrolet Silverado, Viper 5706V, No Start

Home / the12volt's Install Bay / Car Security and Convenience / 2008 Chevrolet Silverado, Viper 5706V, No Start

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

robd007

Member - Posts: 25

Joined: October 29, 2009

Location: Texas, United States

Posted: June 14, 2020 at 1:21 PM / IP Logged

I have this 2008 Silverado 1500 that has a Viper 5706V with a DBALL3 installed. Everything was working fine until recently. The alarm functions properly but it will not remote start. The diagnostics is giving 4 flashes remote shutdown. Any ideas on what would cause this? The dash lights do not illuminate. However the check engine light is lit very dimly. If I start the truck with the key and then remote start with the remote I am able to remove the key and the truck continues to run but other than that nothing else seems to work as far as remote starting. Any info or ideas are greatly appreciated.

Back to Top

silvercivicsir

Copper - Posts: 406

Joined: November 21, 2003

Posted: June 17, 2020 at 3:25 PM / IP Logged

did you put in led tail lights? look for the switch, and make sure it's "on".

Back to Top

Search for other posts by silvercivicsir

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.