the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Compustar Pro T13, Existing Keyless Entry and Push Start, 2016 Subaru Legacy


Post ReplyPost New Topic
< Prev Topic Next Topic >
greeky510 
Member - Posts: 21
Member spacespace
Joined: October 19, 2012
Location: Connecticut, United States
Posted: February 11, 2021 at 12:28 PM / IP Logged Link to Post Post Reply Quote greeky510
Hello people, I am looking to install a Compustar Pro T13 remote start+ security system. That system has keyless entry functionality built into that remote. I want to install it on a 2016 Subaru Legacy 2.5i Limited that already has keyless entry/push button start and remote start. Installers tell me they can't do it and that the car needs to see the signal from the OEM remote in order for the car to be able to drive. I believe they are correct in that. They are saying that there is no way around it. I believe that a way around it is to hide one of the factory remotes in the car, remove the battery and only power it on using an auxiliary output or something when the system is unlocked using the T13 remote and the compustar system sees the T13 remote in range. Also locking the car at the end of the drive would cut off power to the OEM remote and not allow the car to be started if someone were to break the window and use the push button start to start the engine. (The OEM remote will need to be located somewhere far enough from the remote receiver module that's located on the deck lid behind the rear passenger seats, and far enough from the push button area so there will be no chance of the car picking the signal from the remote up even with out the battery in it).
What do you guys think?
Any better suggestions?
Thank you,
Peter M.
silvercivicsir 
Copper - Posts: 280
Copper spacespace
Joined: November 21, 2003
Posted: February 11, 2021 at 2:01 PM / IP Logged Link to Post Post Reply Quote silvercivicsir
wait for compustar to launch it's "KEY LOCKER", and you will be able to due exactly what you want. your current method is dangerous and won't work
greeky510 
Member - Posts: 21
Member spacespace
Joined: October 19, 2012
Location: Connecticut, United States
Posted: February 16, 2021 at 7:57 AM / IP Logged Link to Post Post Reply Quote greeky510
Thank you!

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, May 9, 2021 • Copyright © 1999-2021 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer