spacer spacer spacer spacer

2010 Dodge Charger, Remote Start/Alarm Wiring

Post ReplyPost New Topic
< Prev Topic Next Topic >
Member - Posts: 1
Member spacespace
Joined: June 16, 2021
Location: Ohio, United States
Posted: July 13, 2021 at 10:25 AM / IP Logged Link to Post Post Reply Quote markalan24
I have a Compustar CM900AS Remote Start/Alarm I want to install in a 2010 Dodge Charger SXT. Here’s what I have for the install:
Brain: Compustar CS7900-AS
Bypass: iDatalink AL CA
Harness: ADS HRN-CH4
CM900 Manual:
I’ll be using the harness setup in the lower right image (ADS HRN-CH4). For the “F” wires (ignition, 12v, ground), do I run those directly to the corresponding wires on the brain’s 8-pin connector? Or would I connect those wires from the brain directly to the car, then splice in the wires from the F connector coming from the bypass?
Any help is much appreciated.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Follow Follow on Facebook
Monday, January 24, 2022 • Copyright © 1999-2022, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo spacer spacer spacer
Top spacer spacer