the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2022 Ford XLT Wiring Diagram/Passenger Kick


Post ReplyPost New Topic
< Prev Topic Next Topic >
2022-xlt 
Member - Posts: 1
Member spacespace
Joined: May†21, 2022
Location: Oklahoma, United States
Posted: May†21, 2022 at 2:15 AM / IP Logged Link to Post Post Reply Quote 2022-xlt
I've recently tried installing a light strip for the running boards on my new truck. I've routed the wire up and through to the passenger kick plate. The instructions that came with it were wrong. I've incorrectly tapped into one wire already. There were two that were gray/violet. One was thinner than the other (donít know what it goes to). The thicker one has the right turn signal working. I don't want to go any further without some assistance. Does anyone have a diagram that might help me complete this task?
I've got 4 wires on the strip just need to know what colors to tap into:
1. Door Assist (?)
2. Parking lights (?)
3. Turn signal (Gray/Violet seems to be right side turn signal?)
4. Ground (properly grounded)
I'll check back to see if I need to provide any follow-up info.
Thanks,
J.S.
audiokid1 
Copper - Posts: 117
Copper spacespace
Joined: March†17, 2003
Location: Indiana, United States
Posted: May†21, 2022 at 9:55 PM / IP Logged Link to Post Post Reply Quote audiokid1
1.
Scuff Plate Lights: Connector C2280C at BCM White/Green pin 26
Running Board Lights Left: C3084 on driver side frame rail Violet/Green pin 1
Running Board Lights Right: C3086 on passenger side frame rail Brown/Yellow pin 1
2. Parking Lights
Front: Connector C2280G at BCM Blue/White pin 3
Rear Left: Connector C2280E at BCM Violet/Green pin 26
Rear Right: Connector C2280E at BCM White/Orange pin 51
3. Turn Signals
Front Left: Connector C2280F at BCM Blue/Green pin 39
Front Right: Connector C2280F at BCM Yellow/Violet pin 38
Rear Left: Connector C2280E at BCM Yellow/Violet pin 26
Rear Right: Connector C2280E at BCM Green/Orange pin 52
4. Ground
Use G301 ground point next to SJB/BCM (between BCM and passenger door seal in passenger kick panel). Use 13mm to remove ground nut by hand.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, September 24, 2022 • Copyright © 1999-2022 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer