Cruise Stopped working on 2000 Ranger

Home / the12volt's Install Bay / Cruise Controls / Cruise Stopped working on 2000 Ranger (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bianchina3

Member - Posts: 13

Joined: February 08, 2003

Location: United States

Posted: August 02, 2003 at 7:22 AM / IP Logged

I have a 2000 Ford Ranger that the cruise has stopped working. A remote start was added to the vehicle and everything was fine until suddenly the remote stopped working. I believe the problem is electrical. I don't know where to start trouble shooting.

Powerslave0

Copper - Posts: 116

Joined: November 12, 2002

Location: United States

Posted: August 13, 2003 at 11:52 PM / IP Logged

When you installed the REMOTE starter, you have to use the Tac/VSS signal so the unit knows the engine is running, and releaces the starter. IF that is the case, you are loosing the signal to the ECM, so cruise won't work. However, you should be getting a check engine light too. . . Also, he cool side effect of that is, your SPEED/REV limiter may also be removed. . . It is electrical in this case, you need to get the signal back to the ECM.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Cruise Stopped working on 2000 Ranger

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.