tricky noise question

Home / the12volt's Install Bay / Car Audio / tricky noise question (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

ricetech

Copper - Posts: 64

Joined: December 10, 2002

Location: United States

Posted: September 09, 2003 at 6:20 PM / IP Logged

TO c.c: the pre out voltage on this HU is 4.5 volts. which is where the gain is set. the power is ran away from the fuse block and strait to the batt.

Back to Top

ricetech

Copper - Posts: 64

Joined: December 10, 2002

Location: United States

Posted: September 09, 2003 at 6:24 PM / IP Logged

Ok please explain the last post about the voltage drops. would it be better to use a scope to try to isolate the noise? hey thanks for all the help guys

Back to Top

flatulatta

Silver - Posts: 356

Joined: August 28, 2003

Location: United States

Posted: September 09, 2003 at 6:31 PM / IP Logged

umm how do you have it wired b/c i was told if u run all of ur other wires ie rca and the like next to the power cable u can get a lot of screwed up noises

Back to Top

ricetech

Copper - Posts: 64

Joined: December 10, 2002

Location: United States

Posted: September 09, 2003 at 7:05 PM / IP Logged

Power and signal leads are ran on the opposite side of the car, they cross one factory harness at 90 degrees. anyway the noise i am getting is not the typical vehicle induced noise. it only appears when the cd player is working. the radio is clear. like i said this noise is a pain in my A$$

Back to Top

flatulatta

Silver - Posts: 356

Joined: August 28, 2003

Location: United States

Posted: September 09, 2003 at 7:08 PM / IP Logged

try testing it on another kenwood...... did you buy it in town? if so go back and tell them its f**kin up and u wanna excange or contact kenwood about it

Back to Top

Ketel22

Silver - Posts: 976

Joined: August 23, 2003

Location: United States

Posted: September 09, 2003 at 7:11 PM / IP Logged

i have an extra question, was is it said that running rca's near the power line is bad? mine run on top of each other with no problem.

Quad L Handyman services

Back to Top

flatulatta

Silver - Posts: 356

Joined: August 28, 2003

Location: United States

Posted: September 09, 2003 at 7:18 PM / IP Logged

well iwas talkin to some install guys at a couple of dif places in town here and thats wut they all told me

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

tricky noise question

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.