raised vinyl logo

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / raised vinyl logo (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

amigoboom

Member - Posts: 10

Joined: May 26, 2003

Location: United States

Posted: September 09, 2003 at 10:51 PM / IP Logged

i have made a trunk lid cover and put a 1/8" logo on it. last time i atempted this i used a 1/2" logo and could not get the vynil to form around it. i think it will be easeir now w/ the thinner logo but does anyone have any tips on vyniling this?

lncmarkviii

Member - Posts: 24

Joined: May 16, 2003

Location: United States

Posted: September 10, 2003 at 1:35 PM / IP Logged

use good contact cement, on both surfaces. also try a little heat on the vinal, not so much that you melt the stuff, just enough to make it plyable

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

raised vinyl logo

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.