Passlock II - Flashing Security Light

Home / the12volt's Install Bay / Car Security and Convenience / Passlock II - Flashing Security Light (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

jeffmann

Member - Posts: 4

Joined: October 11, 2003

Location: United States

Posted: October 19, 2003 at 4:23 PM / IP Logged

Apparently, I matched the wrong resistance when bypassing the passlock system. So now the security light is flashing which means the car won't start.

My question is, now that I have removed my passlock bypasser, how do I reset the "security light?" Do I just leave the key in on ON for a half hour like I have read, or is there a reset switch somewhere?

Pontiac Grand AM 03'

-JMann

Back to Top

jeffmann

Member - Posts: 4

Joined: October 11, 2003

Location: United States

Posted: October 19, 2003 at 4:30 PM / IP Logged

Well, leabing the key in for about 10 minutes fixed the flashing security light, I am now just trying to match the resistance values corectly.

-JMann

Back to Top

Alpine Guy

Platinum - Posts: 2,478

This member has made a donation to the12volt.com. Click here for more info.

Joined: October 18, 2003

Location: Canada

Posted: October 19, 2003 at 5:30 PM / IP Logged

make shure the engine is running when you are taking your readings.

Back to Top

HamiltonAudio

Silver - Posts: 278

Joined: October 15, 2003

Posted: October 19, 2003 at 6:40 PM / IP Logged

are you using one of those dip-switch setting units that run in series with passlock? if so, I'd advise against it. two in a row were TOWED back to the shop a few seasons ago cause the unit failed, and took out the passlock signal, so the car didn't even run with the key.

we now use either PL2003 or PLDATA (whichever is most available from suppliers), as they merely "tap into" the passlock system, and don't run "between". if it ever failed, remote start wouldn't work, but the key would. MUCH happier that way!! PLDATA won't work on cavaliers and sunfires....PL2003 works on everything passlock I and II...

b

Back to Top

whiteshack

Member - Posts: 24

Joined: October 18, 2003

Location: United States

Posted: October 29, 2003 at 10:52 AM / IP Logged

turn key on until pass lock light stops blinking then close door lock with factory remotes if equip.or key then open door and start car.

mecp certified installer

Back to Top

bear80

Member - Posts: 21

Joined: August 31, 2003

Location: United States

Posted: October 29, 2003 at 4:55 PM / IP Logged

where do you find a pl2003 or pldata at . is there a wed site to get them

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Passlock II - Flashing Security Light

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.