2004 Solara Remote start info?

Good Morning- anyone deal with a 2004 Solara for remote start ? I could use any wiring info you may have available....Thanks in advance, Steve

Sorry had to transcribe this all... - are negative not dashes.. hope this helps.

12 VOLT: WHT/RED (30A), WHT (7.5A) + Ignition Harness

Starter: BLACK/ White + Ignition HarnessStarter 2: BLACK / YELLOW + Ignition HarnessIgnition: RED / black + Ignition HarnessIgnition 2: BLACK / YELLOW + ignition HarnessACC: Blue/red + Ignition HarnessKeysense: blue - Ignition Harness *1power lock: lt green - drivers kick 20 pin plugpower unlock: blue (double pulse) - drivers kick 20 pin plugparking lamps: green + drivers' kick, harness to reardoor trigger: RED / green (x2) - *2dome supervision: GREEN/ red - r side of fusebox 12 pin plugtrunk pin: GREEN/ red - driver's kick 17 pin plughood pin: black - BECU 10 pin plug pin 10 *3trunk release: WHITE/ blue (5 Wire) driver kick 17 pin plugfactory arm/disarm (arms w/ lock and disarm w/ unlock)tach: BLACK/ orange AC ECM Connector E4 pin 5 *4brake: GREEN / WHITE + @ pedale-brake: RED / white - parking brake switchhorn: GREEN/ black - @ columnheadlights: RED / yellow - headlight switch

LF Window up/dn	GREEN/ YELLOW - red	A	driver window switch in door
RF Window up/dn	GREEN / WHITE - RED / blue	A	driver kick, 20 pin plug

*1 Using the status output to trigger this wire during remote start will disarm the factory alarm without unlocking the doors.

*2 The driver door trigger is RED / green in the driver kick, in a 17 pin plug. The passenger door is RED / green in the passenger kick, in a 12 pin plug. Use both wires and diode isolate each.

*3 The Body ECU is attached to the back of the fuse box.*4  The ECM is behind the glove box. Connector E4 is the top plug. On the 4 cylinder models the tach wire is also found at the data link connector, pin 9, under the driver side dash.