the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Heater AC control by remote alarm?


Post ReplyPost New Topic
< Prev Topic Next Topic >
henrynguyen 
Member - Posts: 7
Member spacespace
Joined: December 10, 2002
Location: United States
Posted: November 20, 2003 at 12:52 AM / IP Logged  
Hi Everyone,
I have a MANNIX alarm system installed in my SC400. So far there isn’t a way I can turn on my HEATER/AC on. The alarm doesn’t have any Accessory wire like other alarms system. This alarm is fully program by the remote. It has the output for Defrost and AUX 1 & 2 for custom installation that can be control by the remote. My car have auto Climate control heater/ac. Is there a way I can use one of the wire from aux 1 or 2 to turn on my heater/ac? Please provide for me some information on how I can connect the relay to turn on my heater/ac. Any help would be nice. Thank You
Henry
birdondubthreez 
Member - Posts: 21
Member spacespace
Joined: November 20, 2003
Location: United States
Posted: November 21, 2003 at 12:33 PM / IP Logged  

If it is a negative trigger from the alarm you would hook up as follows.

#87 - 12volts

#85 - 12volts

#86 - Negative trigger from remote start(aux1 or aux2)

#30 - To your heat wire

If it is a positive trigger from the alarm you would hook up as follows

#87 - 12volts

#85 - Negative ground

#86 - Positive trigger from remote start(aux1 or aux2)

#30 - To your heat wire

HOPE IT HELPS

BiRdOnDuBtHrReEz
sroth140 
Silver - Posts: 513
Silver spacespace
Joined: August 27, 2003
Location: United States
Posted: November 24, 2003 at 2:32 AM / IP Logged  
find out what accy wire turns the heater on.  then use a relay (as listed above) to drive that circuit.  check your programming and see if the brain will keep a signal to the relay once the key takes over or if you have to shut it off with the remote then turn it on from the dash.
HamiltonAudio 
Silver - Posts: 278
Silver spacespace
Joined: October 15, 2003
Posted: November 25, 2003 at 3:21 PM / IP Logged  

what good is heat/ac when the engine isn't running?  I read its an alarm-only system....if engine not running, heat will be cold and ac will be warm...all you're doing is powering the blower essentially..

did I miss something?

b

birdondubthreez 
Member - Posts: 21
Member spacespace
Joined: November 20, 2003
Location: United States
Posted: November 25, 2003 at 9:55 PM / IP Logged  
Why are you asking about your heat and ac(climate control) if you dont even have a remote start. You are very misleading in what it is you need help with. I am just trying to figure out why you would be trying to power up that circuit with only a alarm.
BiRdOnDuBtHrReEz

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, May 14, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer