routher bits

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / routher bits (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Sps70129

Copper - Posts: 55

Joined: September 26, 2003

Location: United States

Posted: December 01, 2003 at 2:35 PM / IP Logged

Just curious about what type and brand of routher bits do you guys use to cut out the rings for a fiberglass box?

iaudio

Copper - Posts: 82

Joined: March 17, 2003

Posted: December 01, 2003 at 8:07 PM / IP Logged

I use an Amana solid carbide spiral upcut bit.

HamiltonAudio

Silver - Posts: 278

Joined: October 15, 2003

Posted: December 10, 2003 at 7:57 PM / IP Logged

using a suitable circle cutting jig, a 1/4" straight cut bit whips thru mdf like cheescake with a good router.

jakita

Copper - Posts: 56

Joined: December 13, 2003

Location: United States

Posted: December 21, 2003 at 7:30 PM / IP Logged

Make sure to wipe blades off with alcohol after each cut to get rid of any residue to extend the life of your expensive bit

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

routher bits

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.