Mazda 6 alarm remote start

Home / the12volt's Install Bay / Car Security and Convenience / Mazda 6 alarm remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

tlp_1977

Member - Posts: 4

Joined: February 17, 2003

Location: United States

Posted: December 01, 2003 at 2:45 PM / IP Logged

I need a wiring diagram for 2003 mazda 6, if any one can help.

Thanks

tsalas469

Member - Posts: 2

Joined: December 01, 2003

Location: United States

Posted: December 01, 2003 at 4:23 PM / IP Logged

this should do it.

12volts	black and BLACK / YELLOW	+	ignition harness
Starter	BLACK/ blue	+	ignition harness
Ignition	blue	+	ignition harness
Power Lock	lt. green	-	DKP or door lock module
Notes: Lock is negative trigger thru a 1.4K ohm resistor. Unlock is a straight negative trigger. MUST use relays. The door lock control module is located above the passenger kick panel.
Power Unlock	same wire as power lock
Lock Motor	RED / blue	5wi	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock Motor	RED / green	5wi	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Disarm Defeat	RED / black	5wi	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+	lt. GREEN/ black	+	driver kick, 14 pin plug
Parking Lights-	RED / white	-	headlight switch
Hazards	blue/orange	-	switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L)	WHITE/ black	+	steering column
Turn Signal(R)	WHITE/ red	+	steering column
Door Trigger	GREEN/ orange	-	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervision	yellow/black	-	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pin	brown	-	DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pin	gray/red	-	pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Release	yellow	-	switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door	N/A
Factory Alarm Arm	blue	-	DKP or door lock module
Notes: Arm is negative trigger thru a 1.4K ohm resistor. Disarm is a straight negative trigger. MUST use relays. The door lock control module is located above the passenger kick panel.
Factory Alarm Disarm	same wire as alarm arm
Disarm No Unlock	use key sense wire
Tachometer	NOT blk/wht or grn/stripe	ac	ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Horn Trigger	PURPLE / white	-	column or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1	N/A
Memory Seat 2	N/A
Memory Seat 3	N/A

Mazda 6 alarm remote start - Last Post -- posted image.

Immobilizer Bypass Module:	Required: Yes	Type: Transponder	Part #: 555U
Notes: N/A

tlp_1977

Member - Posts: 4

Joined: February 17, 2003

Location: United States

Posted: December 04, 2003 at 11:34 AM / IP Logged

Thanks for all the help.

freakystyley990

Member - Posts: 33

Joined: September 25, 2002

Location: United States

Posted: December 08, 2003 at 2:30 AM / IP Logged

This is not the correct wiring chart. While the keyless module IS above the passenger kick panel, the lock wires are not 5-wire. Lock is a straight negative trigger, and unlock is negative trigger, but requires a resistor. However, you must use relays for both. I do not remember the resistance value. Also, the factory disarm wire can be found at this module as well.

Search for other posts by freakystyley990

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Mazda 6 alarm remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.