i need help with a noise problem

Home / the12volt's Install Bay / General Discussion / i need help with a noise problem (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

carriles

Member - Posts: 7

Joined: May 19, 2002

Location: United States

Posted: January 01, 2004 at 8:48 AM / IP Logged

Thanks Gene,

My power and ground wires are ran one the opposite side of my truck than the RCAs.

I was wondering how far my block should be from my amp.

Les

Back to Top

genehewett

Copper - Posts: 151

Joined: December 12, 2003

Location: Georgia, United States

Posted: January 01, 2004 at 8:52 AM / IP Logged

that dose not matter just make sure that the connections at the block are good and tight. what i ment was where the rca's connect to the amp make sure that thay are as far away from your power and ground as possible. sorry.

Back to Top

Overcranked23

Copper - Posts: 67

Joined: December 21, 2003

Location: United States

Posted: January 03, 2004 at 8:46 AM / IP Logged

is your dist Block grounded or is it just a power block??

What kinda grounds do you have and how far apart are they???

don't fowl the track

Back to Top

Julian59

Member - Posts: 24

Joined: January 31, 2004

Location: United States

Posted: February 01, 2004 at 12:38 AM / IP Logged

Gene

If you hav't fixed your problem yet, Try this Real simple. Disconnect the noise source, "the Alternator". if the noise goes away, that's your problem. If not then you have a cold solder joint in the AMP or one of your signal processors

Hope this helps

Julian59

Back to Top

carriles

Member - Posts: 7

Joined: May 19, 2002

Location: United States

Posted: February 01, 2004 at 7:54 AM / IP Logged

Overcranked23 wrote:

is your dist Block grounded or is it just a power block??

What kinda grounds do you have and how far apart are they???

It is just a distribution block,(Stinger) no ground

My ground point is about 12" away and goes directly to the body.

Les

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

i need help with a noise problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.